Wednesday, May 25, 2005

New Picomotor Controllers for Grazing Incidence Interferometer?

Our exisiting picomotor controller seems to have a few issues.
Also, we will need to revive our SGI closed loop controller that integrates the picomotor stages with our solatron encoders.
Maybe we should take a leap and redo all of this....

3 Comments:

Blogger keithgendreau said...

NOTE: For our current setup, we have 10 stages we need to controll:
2 for each mirror * 4 mirrors,
and
1 for the slit assembly
1 for the slit selector.

Since the 6 stage unit will cast ~$1500, we will need 2 of them or atleast 2 more of the 8753 drivers at $500 each for a total of $2500 or so...

ALSO, might need a handpad (8757) at $500... so that would bring the total up to $3k

from http://newfocus.com

May 25, 2005 9:50 PM  
Blogger keithgendreau said...

We could probably also use an upgrade on the breadboard to super invar.
Maybe we should go vacuum compatible.

Non vac-compatible, would be about $6k.

Vac compatible may be twice that amount.

May 25, 2005 9:52 PM  
Blogger keithgendreau said...

Another thing that would be useful would be to have a remotely controllable linear stage for positioning the x-ray source.
This could be another picomoter assembly... we could use the same control for the source slit assembly.
For this we would need an 8763-KIT (3 axis controller with ethernet link.
$995

MAYBE we should get this 1st to see if it is worth it.

May 25, 2005 10:21 PM  

Post a Comment

<< Home