More upgrades for the Beamline
The Current interferometer is built up on a Steel skinned breadboard with lots of aluminum all over the place:

We could also probably upgrade the individual stages:

One thing we really need to think about is the angular resolution needed.
Say we want to position an image to 1 mm at the detector, then we would need to be able to move one end of these 50 mm tilt stages by 1mm/450m * 50 mm = 110 nm. Pico motors give us 20nm steps, but the encoders are only good to 500 nm. I am not sure how we will do this without an upgrade.
We could also probably upgrade the individual stages:
One thing we really need to think about is the angular resolution needed.
Say we want to position an image to 1 mm at the detector, then we would need to be able to move one end of these 50 mm tilt stages by 1mm/450m * 50 mm = 110 nm. Pico motors give us 20nm steps, but the encoders are only good to 500 nm. I am not sure how we will do this without an upgrade.
1 Comments:
NOTE:
1 mm at 450 m is 2 microradians...
Post a Comment
<< Home